Side table complete

Plant stand

I recently finished this plant stand. I didn’t think too much about the dimensions - I was trying to make the most of the QLD walnut leftovers I had. It turned out a bit of an awkward size; not quite a occasional table, not quite a plant stand. Should be ok with a large enough plant on it thought.

It was fun working with non-90 degree angles. I just chose something that looked good and used a bevel gauge for everything, which made things surprisingly easy and I never had to think hard about it.

Everything was finished with a few coats of shellac, and the top also got 2 coats of water-based poly for a bit of extra durability.

Back to blog listing